When using rough terrain scissor lifts, it is really important to use extra caution and be fully aware of your surroundings in order to maintain safety. The long booms on the machine act as levers from the center of the drive unit. Like for example, a 6 inch bump can result in a 3 foot bounce when the driver is at the driver controls. Consider all other traffic in the vicinity, as they may not know that you are moving. Plan your assent carefully. Park the boom lift on a flat surface that has no water or mud. These areas cover deep potholes that can be probably cause the occupants to fall if the tires fell into the holes. If provided, utilize all of the outriggers, fully extended. Be sure to only use approved wooden chalk blocks.
Lots of lifts work from a metal platform on the end of the boom. The extended booms act as levers from the drive unit's center. A 6-inch bump could cause a 3-foot bounce while you are at the driver controls. Be aware of all other traffic. They might not be aware that you are moving. Plan your assent. Park the boom lift on a flat surface free of any mud or water. These areas could conceal deep potholes in which the lift tires could fall, tipping the occupants. Extend all outriggers, if provided, to the full extension position. Place just approved wooden chalk blocks underneath the outrigger pads in order to prevent the unit from moving.
Overhead power lines are a serious hazard for lift drivers regardless of what lift is being used. Like for instance, if the platform driver is not being aware, or if the platform is being controlled by ground personnel which is not able to accurately access proximity to wiring and thus, either the platform itself or the worker could be easily brought into contact with electrical wires. The employee could be electrocuted unfortunately unless correctly insulated.