Change a Propane Tank
Propane fueled forklifts are commonly utilized inside warehouses. The lift truck is made with the propane tank mounted at the rear of the driver. The tanks, which look much like beer kegs, need to be replaced from time to time as they have a limited lifespan. Drivers of forklifts must use care when handling propane tanks. Compressed gases are dangerous, particularly since the gas is flammable. Always utilize caution when removing and replacing propane tank to prevent injury.
1 If there is a need to change the propane tank, the first step is to stop the lift truck, then turn the tank valve off. The forklift must be left on until the engine dies. This procedure burns the gas off in the transfer hose that connects the engine and the tank. Prior to taking the next steps, wear the correct safety equipment, like insulated gloves made of either neoprene or leather. It is vital for you to protect your skin from touching the compressed gas, that is extremely cold.
2 Disconnect the hose from the tank and take the holding straps off to remove the tank. When putting in a new tank, tighten the nut to reconnect the holding straps and to reattach the hose at the valve of the tank.
3 Leaks could be checked just by applying soapy water to the valve and slightly opening it. If there is a leak, it will cause bubbles to foam from around the valve. If this happens, check the valve area and the connection hose at the nut. Re-tighten the connecting nut if you detect any leaks in the valve area, and afterward do the leak inspection process once more. Persistent leaks mean that the nut and connecting hose would need to be replaced. Then again, if replacing the hose and nut still does not stop the leak, the tank would have to be replaced.
4 Finally, open the valve all the way to allow the gas to fill the connecting hose. After that you can start the lift truck and resume working.